In the event you have an infrared device that Simple Control does not already support in our library, it is easy to learn the commands using Simple Blaster’s built-in learner. Simple Control integrates learning functionality directly into the app.
To begin the learning process go to Settings > Code Sets > Add Device. If you do not see the Code Sets item, add a normal infrared device to your configuration first. Once you have learned the commands you need, the command set you learned will then be available whenever you choose Add Device for your Simple Blaster. That’s it! You may either learn an entire command set for a new device, or you might just want to learn a few supplemental commands for a command set already in Simple Control.
We receive numerous support requests from users who thought their device was not supported in our library, assume they need to learn codes, but then find out that it is already supported. We strongly encourage you to check your device carefully against the infrared compatibility list to make sure it or similar models are not there as well as trying the infrared diagnosis steps prior to learning codes. Subtle naming differences such as a model name changing from YSP to YST or other numberings can sometimes be unclear causing confusion as to whether a device is supported. Trying similar command sets can often be a solution to what was initially assumed to require learning codes. Sony products are a particularly common cause of this because they generally always need an increased Retransmit Count. Often even vaguely similar devices use the same codes and greater than 90% of support requests for missing codes actually turn out to be a simple matter resolved by increasing the Retransmit Count, adjusting the emitter, or the other suggestions already in the FAQ above.
Remote Central provides this page that offers many additional tips on learning infrared codes.
For some complex Infrared Learning with supported infrared adapters, or if perhaps you want to edit the codes themselves at a low level, you may also find the following links useful. Please note this is not relevant for any normal infrared learning task. These third-party applications allow control of infrared learning from a desktop system and allow visual inspection of the codes for highly technical users.
After learning the infrared commands using iLearn for a given remote, the commands must be formatted for Simple Control using the instructions in the FAQ on adding Custom Devices. Note that none of these steps are necessary if learning codes from inside Simple Control.